2SETS 5W 433mhz 4 channel wireless switch controller remote control switch module industry class high power

manuel http://einausschalten.com/0060600-y.pdf

Order List

2 piece  Wireless swicth control module- 433mhz

2 piece  Sucker Antenna

1 piece  SK509-S  (Make configeration parameter) with cable

2 piece  Power supply (Frequency according to module you choose) with cable

If you need 470MHz frequency, please leave a massage to confirm when you place order :)

​Product description

it is an industrial four channels wireless switchcontrol module with pairing function,it provides maximum four channel signalinput and maximum four channel control output.It features in simple interfaceand reliable performance.The parameters can bemodified by PC software/UART command/remote controller( SK509-S ).DIPswitch on the module can used to change operating frequency (maximum 16 group),operation mode etc. Using this module, user canreplace wired device with the wireless connection,which significantly reducethe cost and save much time.

Feature

16 predefined channel

Frequency Band:433/470/868/915MHz (Optional)

Parameters configurable by PC software/Remote controller/UART Command

GFSK modulation

Bi-directional wireless switch control

Sensitivity up to 121 dBm

Maximum output power:5W

indicater and alarm when battery low

indicator and alarm when wireless loss link

Working voltage 9~30 V

Working temperature range: - 40~+85 °c

Distanceup to 8Km in open are

Application:

Remote control switch control                            

Home automation remote sensing

Building automation and security

Security system

Wireless remote telemetry

Entrance guard system

Product show

Pin

Pin Description

1) Four-Channel input

This module has a total of four channel signal input (IN1 ~ IN4).

2) Four Channel Relay Output

This module has a total of four channel relay output (OUT1 ~ OUT4). The state of channel output in the Rx side will be synchronized with the Tx in the same channel. The LED will light on when the relay is closed

3) Dip switch Settings (valid when power on again )

DIP8 – normal working mode selection

ON – real-time mode ( In this mode, when state changes in input port , it transmit signal immediately)

OFF - timing mode (Signal transmitted at the predefined time interval)

DIP7 - master/slave selection

ON - the master

OFF - the slave

DIP6 – time interval selection of timing mode

ON - slow time

OFF – fast time

DIP5 - mode selection

ON - normal working mode

OFF - setting mode

DIP4 ~ 1 - working frequency channel selection, total 16 channel, user can freely configure the actually frequency through PC software / UART Command/ Remote controller

Relationship between Dip switch state and working frequency channel

Application connection:

The input port is pulled up internally, leave open or connect with 3.3V will result in high level, it is low level

when connect to GND.

High level will make the output of the other side short out. And low level will make the output of the other

side open. Below is regular connection：

Function Description:

Module can work in the following two modes:

A) real-time working mode

In real-time mode, the module will monitor the four input port status, after status changes, wireless signals will be sent immediately, then in Rx side the corresponding relay status will be synchronized after receiving the signal. Show as below:

Also in this mode, the slave will regularly send inquiries to the master for link status. If no acknowledged signal come to the master, the alarm LED will light on, after the inquiry time is over and all the output relays will be resumed open.

B) Timing mode

In timing mode, the master regularly transmits the signal of the input state. If the slave has not received the master’s signal 5 times interval (fast/slow time) , the LED will light on, and all the output relays will be resumed open..

C) Configuration mode:

In configuration mode, user can configure the parameters by PC software/UART command /remote controller SK108-S. The diagram of PC software is shown below: